Author Guidelines for 8.5 x 11-inch Journal Article

 

¹Author Name, ²Author Name, ³Author Name, ⁴Author Name

^{1, First Author}Author Affiliation, E-mail

^{*2,Corresponding Author}Author Affiliation, E-mail

^3,4Author Affiliation, E-mail

 

 

Abstract

The abstract is to be in fully-justified italicized text as it is here, below the author information. Use the word “Abstract” as the title, in 12-point Times New Roman, boldface type, centered relative to the column, initially capitalized. The abstract is to be in 10-point, single-spaced type, and may be up to 3 in. (18 picas or 7.62 cm) long. Leave two blank lines after the abstract, then begin the main text. All manuscripts must be in English. All text material for 8.5 x 11-inch journal article will be formatted in a single column per page.

 

Keywords: keyword1, keyword2, keyword

 

1. Introduction

 

Congratulations! Your paper has been accepted for journal publication. Please follow the steps outlined below when submitting your final draft. These guidelines include complete descriptions of the fonts, spacing, and related information for producing your journal manuscripts. Please follow them.

 

2. Formatting your paper

 

All printed material, including text, illustrations, and charts, must be kept within the parameters of the 8 15/16-inch (53.75 picas) column length and 5 15/16-inch (36 picas) column width. Please do not write or print outside of the column parameters. Margins are 1 5/16 of an inch on the sides (8 picas), 7/8 of an inch on the top (5.5 picas), and 1 3/16 of an inch on the bottom (7 picas).

 

3. Main title

 

The main title (on the first page) should begin 1 3/16 inches (7 picas) from the top edge of the page, centered, and in Times New Roman 13-point, boldface type. Capitalize the first letter of nouns, pronouns, verbs, adjectives, and adverbs; do not capitalize articles, coordinate conjunctions, or prepositions (unless the title begins with such a word). Please initially capitalize only the first word in other titles, including section titles and first, second, and third-order headings (for example, “Titles and headings” — as in these guidelines). Leave two blank lines after the title.

 

4. Author name(s) and affiliation(s)

 

Author names and affiliations are to be centered beneath the title and printed in Times New Roman 11-point, non-boldface type. Multiple authors may be shown in a two or three-column format, with their affiliations below their respective names. Affiliations are centered below each author name, italicized, not bold. Include e-mail addresses if possible. Follow the author information by two blank lines before main text.

 

5. Second and following pages

 

The second and following pages should begin 1.0 inch (2.54 cm) from the top edge. On all pages, the bottom margin should be 1-3/16 inches (2.86 cm) from the bottom edge of the page for 8.5 x 11-inch paper; for A4 paper, approximately 1-5/8 inches (4.13 cm) from the bottom edge of the page.

 

 

6. Type-style and fonts

 

Wherever Times New Roman is specified, Times Roman, or Times may be used. If neither is available on your word processor, please use the font closest in appearance to Times New Roman that you have access to. Please avoid using bit-mapped fonts if possible. True-Type 1 fonts are preferred.

 

7. Main text

 

Type your main text in 10-point Times New Roman, single-spaced with 10-point interline spacing. Do not use double-spacing. All paragraphs should be indented 1 pica (approximately 1/6- or 0.17-inch or 0.422 cm). Be sure your text is fully justified—that is, flush left and flush right. Please do not place any additional blank lines between paragraphs.

Figure and table captions should be 10-point Helvetica boldface (or a similar sans-serif font). Callouts should be 10-point Helvetica, non-boldface. Initially capitalize only the first word of each figure caption and table title. Figures and tables must be numbered separately. For example: “Figure 1. Database contexts”, “Table 1. Input data”. Figure captions are to be below the figures. Table titles are to be centered above the tables.

 

Figure 1. Class Diagram for Caching Simulator using FIFO, LRU and LRU with related content

 

Table 1. Project selection matrix rules

 

8. First-order headings

 

For example, “1. Introduction”, should be Times New Roman 12-point boldface, initially capitalized, flush left, with one blank line before, and one blank line after. Use a period (“.”) after the heading number, not a colon.

 

8.1. Second-order headings

 

As in this heading, they should be Times New Roman 11-point boldface, initially capitalized, flush left, with one blank line before, and one after.

 

8.1.1. Third-order headings

 

Third-order headings, as in this paragraph, are discouraged. However, if you must use them, use 10-point Times New Roman, boldface, initially capitalized, flush left, preceded by one blank line, followed by a colon and your text on the same line.

 

9. Footnotes

 

Use footnotes sparingly (or not at all!) and place them at the bottom of the column on the page on which they are referenced. Use Times New Roman 10-point type, single-spaced with 10-point interlining spacing. To help your readers, avoid using footnotes altogether and include necessary peripheral observations in the text (within parentheses, if you prefer, as in this sentence).

 

10. References

 

List and number all bibliographical references in 10-point Times New Roman, single-spaced, at the end of your paper. For example, [1] is for a journal paper, [2] is for a book and [3] is for a conference(symposium) paper.

 

[1]     Author1_Name, Author2_Name, “Paper Title ACASH: An Adaptive Web Caching method based on the Heterogeneity of Reference Characteristics”, Journal of AICIT, AICIT(Publication_Name),  vol. 10, no. 4, pp.169-711, 2015.

[2]     Author1_Name, Author2_Name, Web Caching and Replication, Addison-Wesley(Publication_ Name), USA, 2014

[3]     Author1_Name, Author2_Name, “Exploring the bounds of Web latency reduction from caching and prefetching”, In Proceeding(s) of the AICIT Symposium(Conference) on Internet Technologies, pp.13-22, 2009.

 

 

公式格式，一定要放在文本框里面，编号按序列

the graph Laplacian for is . Similarly, it's for . The cost function defined for alignment is defined as

(1)

Here,  denotes the Frobenius norm. Let  and  be the 0-1 selection matrix satisfying , . So the cost function can be rewritten as

 

(2)

 

Where , , .

 

参考文献请严格按下面修改

排版作者注意

 

7. References  引用2篇IJACT的论文，注意格式

 

 

[4]  Peiyi Zhu, Qiang Zhong, Weili Xiong, Baoguo Xu, "A Robust Least Squares for Information Estimation Fusion", JDCTA: International Journal of Digital Content Technology and its Applications, vol. 5, no. 4, pp. 65-73, 2011.

[5]  Zhifang Wang, Shuangshuang Wang, Qun Ding, "Security of Multimodal Biometric Fusion System", JDCTA: International Journal of Digital Content Technology and its Applications, vol. 5, no. 4, pp. 264-270, 2011.

 

[6]   Ming-sheng Hu, Zhi-juan Jia. “Web text categorization on GBODSS”, In Proceedings of 2009 4th International Conference on Computer Science & Education, Nanning, China, pp. 599-603, 2009.

双引号很多有问题，这里的“”不对，要修改为  "    "

单引号  '            '， 不能为 ‘    ’

如果键盘打不出来,COPY过去就行

 

EI源刊发表，是国际知名期刊，在格式上存在严格的要求，以上为格式模版，供需要发表EI论文的人参考。